Ariston Washer Code F-05 Series Of Flashes

An error similar to the first one, says only that the washer does not rotate the drum.

The number of flashes of the LED corresponds to the fault code.

Ariston Washer Code F-05 Series Of Flashes

The indicator blinks by a series of flashes with pauses between series of a few seconds.

When short circuit In this circuit, disconnect the J9 connector and check the wires on the side of the tachometer.

If an asynchronous drive motor is installed, make sure the electrical connection is made between pins 6 and 7 of the J9 connector with the sensor Try to replace the engine, then the electronic module There may be foam on the tachometer, there is also a non-contact in its block.

If this sensor is short-circuited, look for burning tracks in the electronic module.

To inspect the temperature sensor, be aware that its resistance at 20 C is 20 k; it can be measured on pins 11 and 12 of connector J8.

The cause of this malfunction is that the NULL BAK contact group stuck in the sensor, and therefore the washing machine fills the water up to the overflow level.

And as soon as the water reaches the overflow level, the drain pump will automatically operate.

Most often this error occurs due to the ingress of foreign objects into the pump.

It is very easy to check the efficiency of the drain pump, apply 220V to it.

Hey state is checked, for example, on pins 2 and 3 of connector J3, otherwise the level sensor and electronic module are changed successively.

Relay control of the heater check Ring the wires from the connector to the level sensor and connect the heating element with the module.

On many washing machines The EEPROM chip is sealed on the module board.

Re-flush the chip for this you need a programmer and firmware.

Before flashing it is necessary to make a bzkap old firmware, so that you can always roll back to the original firmware.

Measure the resistance of the drain pump winding on connector J15, pins 1 and 2 (if the washing machine has Easy Door function) otherwise on connector J9, pins 8 and 9.

Check the power supply circuit of the heating element for drying, as well as the heating element itself.

On the machines where the display is missing, the error codes are also shown, but in the form of combinations of flashing buttons.

At the same time, the program selection knob constantly rotates to indicate the presence of an error.

We are looking at brushes, motor windings and a tacho sensor.

In addition, the cause of this code may be a malfunction in the electronic module itself.